Knowledge

1. Cleaning and drying Thorough cleaning: Before storage, the residual materials inside the 3D mixer should be thoroughly cleaned to prevent the materials from staying in the machine for a long time,

Daily Maintenance Points 1. Cleaning: Thoroughly clean the inside and outside of the mixing drum after each use to prevent material residue and cross-contamination. 2. Tightening: Regularly check the

1. Explosion-proof certification requirements Check if the equipment nameplate indicates the explosion-proof type, level, and group. The outer casing should be free of cracks, and the junction box cov

1. Regular Maintenance and Care: Regularly clean and inspect the equipment, especially the inside of the ribbon and conical cavity, to ensure normal operation; maintain good lubrication to reduce ener

1. Daily Maintenance (After Each Use) Cleaning and Inspection: Remove residual material from the grinding chamber. Check for wear or looseness of the blades and screen. Lubrication: Add grease to the

1. Equipment Upgrade Replacing the traditional cyclone separator with a high-efficiency turbine classifier can reduce the powder return rate by 15-25% and reduce the energy consumption of repeated gri

1. Liquid Nitrogen Pre-cooling Directly spraying or impregnating materials with liquid nitrogen (-196℃) rapidly embrittles them, reducing frictional heat generation during grinding. Suitable for heat-

1. Control the feed speed Feeding too quickly can lead to material accumulation and increase the risk of agglomeration; feeding too slowly reduces efficiency. It is recommended to adjust the feed spee

Typical symptoms and diagnostic methods for clumping problems: 1. Decreased output Clumping causes material to adhere within the grinding chamber, forming a "ball-like" phenomenon and reduci

1. Feed Speed ​​and Uniformity Maintain a stable feed speed to avoid material accumulation or flow interruptions caused by sudden changes in speed. It is recommended to use a quantitative feeding devi

1. Power Off and Disassembly Turn off the power, disconnect the power cord, loosen the screws securing the blade with a wrench, and separate the grinding chamber from the motor. For the 10-liter model

1. Abnormal Operation Abnormal noise (such as metallic friction or impact sounds) or significantly increased vibration may indicate loose blades, worn bearings, or foreign objects entering the grinder